Echowell zone 7 instructions
The VDO logo of the rod-shaped magnet core should point toward the transmitter. Place the spoke magnet around an outside spoke. Fit the transmitter on the same side of the forks where you later want to fit the computer to the handlebars (right or left) using the cable ties supplied (loosely at first, do not pull tight just yet).ĪTTENTION: The cross-hatched marking on the lid of the transmitter‘s battery compartment must point toward the spokes.ĭepending on the available space, the transmitter can be mounted along the front of the fork, on the inside of the fork, or the back of the fork. Place the rubber shim under the transmitter. If you have attached the computer to the stem or the left of the handlebars, the speed transmitter MUST be attached to the LEFT fork leg. The transmitter can be attached to the fork leg on the right or left. If this value is exceeded, the total ride time count restarts at zero. The total ride time counts up to 9999:59 HHHH:MM. Now press theTPC (TOTAL/PULSE/CAD) button to scroll to the total ride time If the unit is switched from miles to km and the conversion result is greater than 100,000 km, the value is reset to ZERO. If this value is exceeded, the total distance counter restarts at zero. The total distance counts up to 99,999 km or miles. There are two options for displaying the totals.Īccess the totals by pressing the TPC (TOTAL/PULSE/ĪTTENTION: if you have activated the HEART RATE option, the total values can be accessed via the menu. The total values for the distance travelled, the ride time and the altitude data are accessed separately to the data for the CURRENT trip.
#Echowell zone 7 instructions how to
Information on how to operate the navigator can be found on page 64.ĭisplays the downhill distance travelled on the current trip. – count forwards or backwards from this value – be reset to ZERO as often as desired and independently of the trip distance counter The navigator is particularly helpful when riding a route shown in a road book (e.g. The navigator is used to measure trip sections. The navigator is a second, completely independent trip distance counter. Shows the distance travelled while the trip section counter is activated. The trip section counter is started and stopped by pressing the BIKE + SET buttons (simultaneously press and BRIEFLY hold both buttons).ĪTTENTION: the trip section counter stops automatically when the speed is ZERO. When the trip section counter is running, the section distance is also recorded.
If the trip section counter is running, the section time is recorded, as with a stopwatch. The trip section counter is like a stopwatch. – Exit setting mode/one level back/back to function mode – Access the altitude recalibration (press and hold) – Access the altitude data for the current trip Replacing the battery in the speed transmitter. įunctions with heart rate and cadence options. īutton allocation with the heart rate option. ĭisplay when using the heart rate option. Resetting the trip section counter to zero. Recalibrating the altitude before starting.